TIE HEADSAIL CLEW TO ROLLER FURLING FREE

The sail is partly reefed by attaching the sheets to the leech cringle. The reefing line is led from the bow fitting through the cringle and the tack to a cleat.Īn unreefed headsail with one row of reefing cringles The area to be reefed is shown shaded When the halyard is eased, the reefing line is pulled to lower the luff cringle. Once the sail is reefed, the foot of the sail should be secured by lacing cord through the cringles. When the sail is lowered sufficiently, and the cringle pulled tightly down, the line is cleated Ease out the halyard so that the cringle can be brought down to the tack by pulling on the reefing line. The sail should be allowed to flap slightly.

If you arc reducing the luff, rig a reefing line through the luff cringle as shown below. (windward) sheet and attach it in the new position and then heave-to with the headsail aback to move the leeward sheet. Step 4 Then Pass the loop through the middle of the Dixon Clew.

TIE HEADSAIL CLEW TO ROLLER FURLING FREE

Step 3 Pass the free end of the loop through the ring on the sail. Step 2 Then pass it back through itself to create a cowhitch. When reefing the headsail it is necessary to remove and reattach each of the sheets in turn. Step 1 Pass the loop through both eyesplices on the sheets. If the sail has only a single row of cringles, the amount by which the sail can be reduced can still be varied (see below). The sail may have one or two rows of cringles or reefing points running parallel to the foot. Attach the spinnaker sheet to the clew ring of the spinnaker and make sure the line is led aft outside the lifelines to a turning block on the toerail located just forward of the stern pulpit. Some boats carry headsails which are designed for points reeling. Set up the tack downhaul so the tack of the sail is about five feet above the deck when the sail is hoisted. Furling the headsail completely around the headfoil. The headsail is furled by pulling on a wire which rotates the drum and the headsail. Always make sure that a headsail stowed on its stay for any length of time is protected from sunlight with a cover. The whole headfoil is rotated by a wire fitted to a drum at the base of the forestay so that the sail is wound evenly around the foil from tack to head. The most effective system uses headfoils (see pages 214-5). When deciding on a headsail reeling system of this kind, it is a good idea to seek the advice of your sailmaker to make sure that your sails are suitable. Furling, a method of stowing the headsail by winding it around the forestay, has been in use for many years but recently, furling systems have been developed to allow the headsail to be roller reefed.

Tie headsail clew to roller furling